PROGRAMMING INSTRUCTIONS

Ether-ComTM

Description

The Ether-ComTMSingle Port Router allows a DMP 1912XR, XR200 or XR200-485 Command ProcessorTM panel to communicate to a DMP SCS-1 Receiver using an existing Ethernet network. The router operates as an interface between the panel and the network.

What’s needed

Additional equipment needed to program the Ether-ComTM:

386 or better laptop or PC

WindowsTM 95 or 3.1 with a communication software package such as HyperterminalTM or TerminalTM DMP Model 396 programming cable

10BaseT Ethernet cable

Configuration for use with a DMP 462N or 862N

The following configuration is designed for applications where the Ether-ComTMserver is used as the interface between the DMP 462N or 862N Network Interface Card on a 1912XR/XR200/XR200-485 panel and an ethernet network.

1912XR/862N orXR200/462N

Configure the communication software package on your laptop or PC for 9600 baud, 8 bits, no parity 1 stop bit and no flow control. Connect the DMP Model 396 programming cable to the COM port on your laptop or PC that you configured in your communication software. Connect the other end of the Model 396 programming cable to the Ether-ComTMconnector supplied with the unit.

DO NOT CONNECT the Ether-ComTMto an Ethernet network at this point. Apply power to the unit. If the unit passes its power-up diagnostics the following message should be displayed:

Ethernet Address:

00-80-a3-0f-4a-d4

Internet Address: 10.17.39.1

Flash Rom Version

2.0 (May 12, 1998)

 

 

Flash Version:

3.5/1 (970707)

 

 

Current Diagnostics report:

 

 

NVR Config:

Normal

Ram Size:

256 KB

CPU Speed:

10 MHz

Gate Array:

Rev 2

Flash Version:

3.5/1 (970707)

Ethernet: None

 

Errors:

Network

 

 

No network was detected. Press a key within 10 seconds to access bootmode commands>

Press the Return key to access the Boot> prompt.

Enter the following commands at the Boot> prompt:

1.CHANGE BOOTP DISABLED

2.CHANGE DHCP DISABLED

2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282

Downloaded from: http://www.guardianalarms.net

LT-0424 (1/99)

Page 1
Image 1
DMP Electronics LT-0424 manual Description, What’s needed, Configuration for use with a DMP 462N or 862N