Figure 2: Jumper plug settings for High dB and Code 3. | Figure 3: Jumper plug settings for Low dB and Continuous Horn. | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 4: Jumper plug settings for Low dB and Code 3.Figure 5: Jumper plug settings for High dB and Continuous Horn.
(Use needle nose pliers to pull and properly set the jumper plugs.)
No jumper plugs are needed for Continuous Horn and low dB settings. However, it is recommended that the jumper plug be retained in the unit for future use (if needed) as shown in Figure 3, 4 and 5.
Note: The Audible Horn Strobe must be set for code 3 when used with the sync module.
WIRING INFORMATION:
Figure 6. | Figure 7. | |||
|
|
|
|
|
|
|
|
|
|
When the sync module is used, the audible tone will be the code 3 sound only. Refer to Sync Module installation instruction sheets Sync Module (P83850) and Dual Sync Module (P83844) for additional information.
1)Audible Horn Strobe Appliances have
2)Break all
P83848 A Sheet 4 of 7