CONNECTING THE TRIMMER UNIT TO THE POLE
Important:
Make sure that the engine is turned off, and remove the spark plug cap before assembling the pole hedge trimmer.
Wear protective gloves!
Secure blades with the blade cover provided when connecting the trimmer unit to the pole.
-Loosen the M5x10 screw and M5x25 bolt.
-Insert shaft into gear case
NOTE: Make sure that the shaft is completely inserted into the gear case (approx. 40mm/1.57").
If you are having trouble inserting the shaft, manually rotate the drive axle a little and try again.
-Confirm that the shaft is properly inserted and then tighten the M5x10 screw and the M5x25 bolt.
Drive axle | M5x10 screw |
40mm
Shaft | M5x25 bolt |
|
ATTACHING THE HANDLE
-Attach the protective barrier together with the handle so that the barrier juts out to the left as viewed from the operating position.
-Make sure not to set the handle too close to the control grip (use the distance collar provided for this purpose).
to engine
USING THE SHOULDER STRAP
How to wear the shoulder strap
-Wear the shoulder strap over the left shoulder.
-Keep the pole hedge trimmer unit on the right hand side of the body.
-Attach the strap to the fitting provided on the pole hedge trimmer and adjust the length of the strap to attain a comfortable working position.
Detachment
-In an emergency, push the notches (1) at both sides, and you can detach the machine from you.
Be extremely careful to maintain control of the machine at this time. Do not allow the machine to be deflected toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the machine at all could result in serious bodily injury or DEATH.
Hanger
Shoulder strap Wear over left shoulder
9
