![](/images/new-backgrounds/1272045/27204511x1.webp)
VACUUM TOILET OPERATION
| 1. To add water to the toilet before | 2. To flush toilet, press flush lever | 3. Do not dispose of sanitary napkins |
|
| using, raise flush lever until desired | sharply down to the floor until contents | or other |
|
| water level is reached. Generally, more | clear bowl. A sharp popping noise is | such as facial tissue or paper towels. |
|
| water is required only when flushing | normal when the vacuum seal is bro- | These items can cause plugging of the |
|
| solids. | ken and flushing action begins. | system. Refer to the Deodorants and |
|
|
| Be sure to hold lever down for three | Special Tissue section in this manual |
|
|
| seconds. If flush lever is accidentally | for more information. |
|
|
| released before waste clears bowl, do |
|
|
|
| not attempt to flush toilet again until |
|
|
|
| vacuum pump stops running. A small |
|
|
|
| amount of water should remain in the |
|
|
|
| bowl after flushing. |
|
|
|
|
|
|
|
|
|
|
|
|
HOLDING TANK OPERATION – DISCHARGE
1.Position vehicle close to sewage dumping facility.
2.Unroll discharge hose, remove plastic cap, and insert end into dumping facility.
3.Activate discharge pump.
4.After tank is empty, the tank can be rinsed. (Note: Rinsing systems vary by vehicle. Consult vehicle dealer.)
5.Discharge rinse water into dumping facility. Drain all water from discharge hose. Put plastic cap on end of hose. Roll up and store hose.
CLEANING – HOLDING TANK
A small amount of water remains in all holding tanks. It is good practice to rinse the tank after the contents have been discharged. This can be accomplished by adding water to the toilet bowl. Add 237 ml (8 oz.) of SeaLand® Holding Tank Deodorant to the bowl. Flush the entire contents into the holding tank and continue flushing until the discharge from the holding tank is clear.
Do not use
WINTERIZING – HOLDING TANK
If using antifreeze to winterize the holding tank system, use only propylene glycol freshwater antifreeze that does not contain alcohol. Antifreeze that contains alcohol will result in damage to your sanitation system.
1.Pump out holding tank.
2.Thoroughly flush the system with fresh water before adding propylene glycol freshwater antifreeze to the HTS.
3.Turn off electrical power.
6