Dometic 3100, 3000 owner manual Table of Contents, Toilet Model Identification

TABLE OF CONTENTS

Toilet Model Identification	. . . 2	Deodorants and Special Tissue	. . .	. . 8
Important Information Before Operation . . .	. . . 2	Marine Sanitation Regulations	. . .	. . 8
Operating Instructions	. . . 3	Flush Mechanism Components	. . .	. . 9
Flush Operation Timing Chart	. . . 4	Manual Flush Operations	. . .	. 10
Cleaning – Toilet Bowl and Seal	. . . 4	Electrical Specifications	. . .	. 10
Winterizing	. . . 4	Troubleshooting	.11	– 14
Clearing Discharge Lines	. . . 5	RV Wiring Diagrams	15	– 16
Maintenance Schedule	. . . 5	Marine Wiring Diagrams	17	– 21
Spare Parts	. . . 5	Dimensions	. . .	. 21
Ordering Parts	. . . 5	Customer Service	. . .	. 22
Sanitation System Components	6 – 7	Limited Warranties	23	– 24

WARNING – ELECTRICAL SYSTEM.

Turn off electrical power before servicing.

WARNING – MOTOR STARTS AUTOMATICALLY.

Turn off electrical power before servicing.

CAUTION – System may contain vacuum after shut-down.

Read and understand the complete contents of this manual before operating or servicing the sanitation system. Failure to follow any precautions may result in damage to the sanitation system.

TOILET MODEL IDENTIFICATION

The model identification label is located on the inside wall of the toilet under the tank access cover. It will show the model number and serial number.

DOMETIC CORPORATION

P.O. BOX 38, 13128 STATE RT 226 (800) 321-9886 BIG PRAIRIE, OH 44611 USA

MODEL NO. 000

SERIAL NUMBER

000000

IMPORTANT INFORMATION BEFORE OPERATION

1.Fill freshwater tank and add deodorant to holding tank through toilet bowl.

2.Make sure all guests understand toilet operation and that the flushing instruction label is easy for guests to read.

This label (see below) is located under the seat, and is easily seen when the seat is raised.

3.Remember, the vacuum pump starts automatically. Shut off the toilet system before servicing and do not leave the boat with toilet system breaker on.

4.Never use drain openers, alcohol, solvents, etc. in the system.

5.If the system does not function properly, refer to the Troubleshooting section of this manual and repair as necessary. If problem persists, contact your local SeaLand dealer or see the Customer Service section of this manual.

1.To add water to bowl before using (if necessary), raise flush handle until desired water level is reached. (Water

flow will stop automatically after a period of time).

2.To flush, press flush handle down. Water will flow into bowl for two seconds, then flush ball will open. Toilet will not flush again until “OK to Flush” light is on.

3.Do not dispose of sanitary napkins or other non-dissolving items in toilet, such as facial tissue or paper towels. These items can cause plugging of the sanitation

system.

2