![](/images/new-backgrounds/1046940/4694011x1.webp)
STEP 16: With toilet close to floor flange, connect flex- ible water supply hose to the water line fitting (fig. 17).
Fig. 17
STEP 17: Insert the positive (+) 12 VDC wire into position 1 of the green terminal block and tighten the screw securely. Insert the negative
Fig. 18
STEP 18: REMOVE RED CAP FROM MIDDLE
OF FLANGE ADAPTER BEFORE FINAL TOILET INSTALLATION.
IMPORTANT – DO NOT ATTEMPT TO SLIDE THE TOILET OVER THE FLANGE ADAPTER. THE TOILET MUST BE SET DOWN OVER THE ADAPT- ER TO PREVENT POSSIBLE DAMAGE.
STEP 19: Set the toilet in place (fig. 19) and secure to floor with the
Fig. 19 |
| Fig. 20 |
|
|
|
Fig. 21
STEP 20: Place the rear access cover on the back of the toilet. Press down firmly to seat the fastening strips.
STEP 21: Turn on electrical power and water to toilet. Lift flush handle and fill toilet bowl with water. Wait one hour, then inspect the floor around and under the rear of the toilet for leaks or dampness.
If no leaks are present, toilet is ready for operation.
6