7.INSTALLING REFRIGERATOR IN ENCLOSURE
NOTE: DO NOT install the appliance directly on car- peting. Carpeting must be removed or protected by a metal or wood panel beneath the appliance, which extends at least the full width and depth of the appli- ance.
FIG. 3
The dimensions shown in FIG.3 will give you adequate space for service and pro- per installation.
RM 4223 | Overall |
|
| Installation |
|
| Recess |
| Distance between | |
| Dimensions |
|
| Dimensions |
|
| Dimensions |
| Top of condenser and | |
|
|
|
|
|
|
|
|
|
| Top of refrigerator |
|
|
|
|
|
|
|
|
|
|
|
Vent | Height | Width | Depth | Height | Width | Depth | Height | Width | Depth |
|
Type | A | B | C | h | w | d | H | W | D | e |
Dual Metal | (inches) |
1/4”
Side Vents | (mm) |
539 537 641,5
524,5 491 602,5
530,5 497 610
6
Dual Plastic (Inches)
1/4”
Side Vents | (MM) |
539 537 641,5
524,5 491 602,5
530,5 497 *610
6
*Depth “D” Dimensions Requirement with Plastic Vent System is Dependant on Vehicle Side Wall Thickness. If the Vehicle Side Wall Thickness is less than 1,5 inches ( 38mm ), the Recessed Depth Dimensions will be required to be Increased Proportionally to the Vehicle Wall Thicknes.
A. INSTALLATION
The refrigerator must be installed in a substantial enclo- FIG. 4 sure and must be level. When installing the refrigerator
in the enclosure, all areas within the recess in which the refrigerator is installed must be sealed from the living space.
Make sure that there is a complete seal between the front frame of the refrigerator and the top, sides and bot- tom of the enclosure. A length of sealing strip is applied to the rear surface of the front frame for this purpose, see FIG. 4. The sealing should provide a complete isola- tion of the appliance's combustion system from the vehicle interior.
Note: Be careful not to damage the sealing strip when refrigerator is put in place.
4
