English
Operation
Communication between the handsets
1.Ensure that you use the same channel, e.g. 1.
2.Hold the handset approximately 10 cm in front of you at face height.
3.Press and hold the PTT button, wait a second and then speak clearly towards the handset. Release the button when you have finished speaking.
4.The handset is now ready to receive.
5.If nobody answers, try sending a CALL signal by pressing and holding the PTT and vbuttons simultaneously.
6.The handset will automatically revert to
Please note!
If the handsets are unable to communicate this may be due to different channels being selected, low batteries or if handsets are out of range.
Volume control
The receive volume can be adjusted by using the v/Vbuttons. The display will show the selected setting VOL.
Monitor function
The handset will usually receive all calls on the selected channel.
If the signal is weak (ie the handsets at maximum range), the monitor may be used to listen for any transmission within range on the selected channel.
1.Press and hold the MON button until you hear a beep.
2.To disable the monitor function press and hold the MON button again.
Signal search
You can scan all channels to locate a PMR unit that has a signal.
If a signal is located, the display will show the channel number and the signal will be heard. Press the PTT button to remain on the located channel.
1.Press and hold the 
button until the unit starts searching.
2.Press and hold the 
button again to stop searching.
When searching battery power consumption will be four times higher than in
6 | www.doro.com |
