Assembly Instructions

Truss-Style Cinefold Portable Projection Screen by Draper

Caution

Read instructions through completely before proceeding; retain for future reference.

Handle viewing surface with care; do not allow it to come in contact with sharp or dirty objects.

Use Handy Cranks provided; failure to do so may lead to screen dam- age.

Make sure screen is level.

Do not write on viewing surface.

Truss Assembly

Remove pouch containing viewing surface from case and set aside.

Remove all aluminum assemblies.

Unfold all folded aluminum assemblies completely, noting labels and color-coded marks. Lock all hinges. Position Stage Right and Stage Left

sections in appropriate positions with snaps facing up. Top and Bottom sections should be set with snaps facing down.

To increase frame rigidity, hinges on top and bottom frame sections have rivnuts marked with red and green. Insert a Handy Crank through the threadless rivnut (red) and tighten into the threaded rivnut (green).

Apply small sections marked “Stiffener Bars” to back of Bottom frame section, using eight Handy Cranks each. Failure to use all Handy Cranks

may result in damage to screen frame. Turn Bottom frame section over so snaps face up.

If your screen frame is less than 25' wide, repeat step 4 for Top frame sec- tion. Frames 25' wide and over are equipped with a special full-width Stiff- ener for the top frame section. To attach it, place Stiffener fl at with green rivnuts face down. Place top frame section on top of and at right angles to Stiffener, over the green rivnuts. Insert and tighten standard Handy Cranks. Install 45° angle braces to the Top frame section and Stiffener with

Caution: Make sure all hinges and joints are locked before raising screen to standing position.

short Handy Cranks. Turn Top frame so snaps face up.

Join Top and Bottom to Stage Right and Stage Left, using two Handy

Cranks on each of the four corners. Match numbers on white labels, and keep in mind that no Handy Crank should protrude outside screen frame.

Remove surface from pouch. With the row of male snaps at bottom, posi-

tion screen surface over frame. Snap each of the four corners, then snap across bottom, up sides, and across top.

Attach feet to inner side of legs with Handy Cranks, matching color-coded

markings. Attach legs to Stage Right and Stage Left with Handy Cranks, matching colored tapes.

Raise screen to a vertical position. Add Heavy-Duty Legs and Anti-Sway Stabilizers with Handy Cranks in the positions indicated below.

Handy Crank

Rigid

Truss

Frame

Caution: Make sure screen is placed on level surface.

 

Frame & Legs

Anti-Sway

Assemble with

Handy Cranks

Stabilizers

 

Heavy-Duty

Legs

®

Copyright © 2008 Draper Inc.

Form Cinefold_Inst08 Printed in U.S.A.

Caution: Beware of pinch points.

 

Valance Bar

Drapery

Drapery

Bar

Bar

Adjustable Skirt Bar

Dress-Up Kit Assembly

PLEASE NOTE: All components are labeled and color coded to facilitate assembly.

A.Valance Bar attaches to frame with simple bayonet-style mounting.

B.Draper Bars mount to Valance Bar, bayonet-style.

C.Optional adjustable Skirt Bar is secured to frame at desired level with positive-locking plunger mechanism. If Skirt Bar is not used, Skirt may be snapped to bottom of viewing surface.

D.Valance, Drapes, and Skirt snap onto Mounting Bars.

Page 2
Image 2
Draper manual Truss-Style Cinefold Portable Projection Screen by Draper, Truss Assembly, Dress-Up Kit Assembly