Rear Wheel Installation:
A. Remove 16” wheels from plastic bags. B. Remove foam cover from wheel axle. C. Place rear footbrake in upright position.
D. Push on the black cap in the center of the wheel, and insert it into the rear stroller frame axle. Give the wheel a tug to make sure it is locked into place.
To remove the rear wheels, make sure that the footbrake is in the upright position. Push on the center of the black cap that says push and pull wheel axle out of the stroller frame.
WARNING: Be sure to discard plastic bags and packaging from the wheels, they are a suffocation hazard to children. Check to make sure your wheels are locked before each use.
Front Wheel Installation:
A. Tip the stroller back so it is resting on its handle and rear wheels to put the front wheel on.
B. Remove 12” wheels from the plastic bag, remove the foam protector.
C. Find the flat sides of the round axle and slide all of the way to the back of the fork tips on both sides.
D. The quick release lever should be straight out. While holding the lever, tighten the thumbnut until it is snug. The axle should not move side to side.
E. Flip the quick release lever down so it is flush with the frame. Give the wheel a tug to make sure it is secure.
F. Repeat steps C through E for second wheel.
To remove the front wheel, tip the stroller back so it is resting on the handle and rear wheels.
Flip the quick release lever, loosen the thumbnut just enough to allow the front wheel to be pulled from the fork tips. Do not loosen the the thumbnut too much or the internal spring will pop out.
WARNING: Check to make sure the stroller wheels are secure and locked before each use.
Now your stroller is ready to roll! Read on to learn about the features that your new Dreamer Design stroller has...
Dreamer Design |
