Dremel 335 warranty Operating Instructions, Under a router or saw table Inserting the Router Bit

DM 2610920458 2-04 2/19/04 12:24 PM Page 4

Operating Instructions

ATTACHMENT FOR USE WITH DREMEL HIGH SPEED ROTARY TOOL MODELS 275, 285, 395, & 398.

ATTENTION: This attachment will convert Dremel Rotary Tool to a Plunge Router for freehand routing, edging, grooving, and

circular cuts. The router attachment comes assembled ready for freehand or pilot bit routing.

!WARNING This Router Attachment is not intended for use

under a router or saw table.

Inserting the Router Bit

The router bits are held in the tool by a collet system. The bit may be installed before or after the rotary tool is installed in the attachment.

1.Depress and hold the shaft lock button while rotating the collet nut and shaft. Continue to rotate the collet nut and shaft until the lock engages and holds the shaft (Fig. 4).

2.Use the wrench from your Dremel Rotary Tool and turn the collet nut counter- clockwise to loosen it.

3.Release the shaft lock button.

4.Insert the router bit into the collet as deep as possible to ensure proper grip- ping of the bit and to minimize run out. Do not insert the bit so far that bit flutes touch the collet or collet nut to avoid chipping or cracking the bit.

NOTE: Never place the tool with bit protruding through base on top of bench or work surface. Lay the tool on its side or retract the bit before setting on bench or work surface. Protruding cutting bit may cause tool to jump.

5.Re-engage the shaft lock button and tighten the collet nut; first by hand, then using the wrench until bit is held securely.

FIG. 4

Shaft Lock

Button

Collet Nut

Collet Nut

Wrench

Base

4