![](/images/new-backgrounds/1088630/8863013x1.webp)
DM 2610958399
Assembly
!WARNING Disconnect the plug from the power source before
making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
!WARNING For all work or when changing accessories
always wear protective gloves. Such preventive safety measures reduce the risk of injury from sharp edges of the accessories. Application tools can become very hot while working. Danger of burns!
INSTALLING AND REMOVING
ACCESSORIES
Dremel cutting, scraper blades have a Quick- Fit slot which allows for faster accessory removal compared with other conventional oscillating tool systems.
1.Loosen the clamping screw using the hex key provided just enough so you can slide the accessory between the accessory holder and the blade washer (Fig. 2).
2.Clean accessory holder, accessory and the clamping screw with a clean cloth.
3.Place the accessory onto the accessory holder making sure the accessory engages all 12 pins in the holder and the accessory is flush aganist the accessory holder.
4.Securely tighten the clamping screw with the hex provided (Fig. 3).
NOTE: Some accessories, such as scrapers or blades, may be mounted either straight on the tool, or at an angle to enhance usability (Fig. 4).
INSTALLING AND REMOVING
SANDING SHEETS
Your backing pad uses
1.Align the sanding sheet and press it onto the sanding plate by hand.
2.Firmly press the power tool with the sanding sheet against a flat surface and briefly switch the power tool on. This will promote good adhesion and helps to prevent premature wear.
3.To change, merely peel off the old sanding sheet, remove dust from the backing pad if necessary, and press the new sanding sheet in place.
After considerable service the backing pad surface will become worn, and the backing pad must be replaced when it no longer offers a firm grip. If you are experiencing premature wear out of the backing pad facing, decrease the amount of pressure you are applying during operation of the tool.
For maximum use of abrasive, rotate pad 120 degrees when tip of abrasive becomes worn.
FIG. 2
| CLAMPING |
ACCESSORY | SCREW |
HOLDER |
|
BLADE
WASHER
HEX
ACCESSORYKEY
FIG. 3
CLAMPING
SCREW
HEX KEY
FIG. 4