050107_Quark file for Blender.qxp 1/10/2007 10:59 Page 9
CORD STORAGE
•To vary the length of the power cord/cable uncoil from storage area beneath powerbase. Fig. 3
PULSE FEATURE
•Ensure the blender is fully assembled and in place on motor base. Place ingredients into the jug and firmly attach the lid.
•Switch blender “on”10 ,the red “standby” 9 light will flash.
•Press pulse button 8 , green light 9 will glow and blades will rotate at full speed until button 8 is released.
•Only use rubber spatula to mix foods when blender lid is removed, the speed knob is at speed 1 and the blades are stationary.
TURBO PULSE
•When blending at any speed the pulse button 8 can be pressed for full speed and will hold full speed until pulse button is released and speed will resume speed on knob 6 .
FILLER CAP/ BLADE KEY
•Remove cap 1 and add ingredients only at slow speeds.
•When using at high speed, with a full jug or with warm contents, stop blender and then add ingredients.
•The filler cap doubles up as a key for removing the blade assembly from the Jug for cleaning.
CLEANING
•Switch off, unplug and
•Do not let the power base, flex or plug get wet.
•Wipe power base with damp cloth, then dry.
•All other parts can be washed in dishwasher, using a low temperature cycle, then dry.
•To clean the jug, quarter fill with warm water, add a few drops of washing liquid and whizz for 30 seconds. Rinse.
•To remove blade for cleaning, follow procedure on page 5.
•Do not touch the blades - brush clean under a tap/faucet. Then leave to dry out of children’s reach.
•Warning: Do not immerse or wash jug in boiling or very hot water above 60°c.
.
REPLACEMENT CORD / SAFETY SYSTEM
If the power cord is damaged it must, for safety reasons, be replaced by Dualit or an authorised Dualit repairer.
If blender fails to operate refit lid ensuring correct positioning of the plunger into the Safety Interlock System and/or unplug for 15 minutes, plug in and try again.
Ensure the blade assembly is correctly fitted.
If problems persist, either contact the shop where you purchased from, or telephone Dualit.
In UK call Dualit Care Line 01293 652 500 or email:info@dualit.com
9
