TROUBLESHOOTING

PROBLEM

 

CHECK and CURE

IMPORTANT

 

 

 

 

 

IGNITION SYSTEM

Be sure that there is gas fl ow to the burners by attempting to match light your burners.

 

 

If match lighting is successful, the problem lies somewhere in the ignition system and

 

 

will need to be checked.

 

 

 

 

 

 

MAIN GRILLING BURNERS

 

 

 

If the main burner(s) still fails to ignite, make

 

 

CAUTION: Always turn the gas supply off at the tank before

sure that there is gas fl owing to the burner(s) by

 

 

attempting to match light the burner(s). If the

 

 

proceeding with any troubleshooting procedures.

 

 

 

burners will match light, then proceed with the

 

If, for any reason, the snap ignition fails to ignite the main grilling burner(s), repeat the

ignition checkout.

 

If for any reason the igniter system is still

 

lighting procedures described on the grill control panel.

 

inoperative, follow match lighting instructions.

 

 

 

 

 

 

WARNING: The hood must be in the full open position any

 

 

 

time you attempt to light your grill. Failure to open the

 

 

 

hood could lead to delayed ignition resulting in bodily harm.

 

 

 

 

 

 

After shutting off the main gas supply, remove the cook grate and heat distribution

 

 

 

plates. Turn snap igniter counter clockwise and check if the electrode is sparking to the

 

 

igniter tube. Try the snap igniter several times.

 

 

 

 

 

 

BURNERS WITH POOR FLAME

Check to be sure burner ports, shutter, end of the burner (venturi) and orifi ce(s) are free

If you still have a poor fl ame, please contact

 

of any obstructions. Also, if your grill has been stored over a prolonged period of time,

dealer for futher assistance or call Customer

 

check to make sure no spiderwebs have been formed in the shutter end of the burner

Service

 

(venturi) or over orifi ces.

 

 

On an LP grill, if an extremely low fl ame is present, or is hard to ignite, the

 

 

ow-limiting device may have activated. To reset the fl ow limiter turn all burners control

 

 

knobs to “high”. Wait at least 1 minute. Turn burner control knobs “OFF”, reconnect the

 

 

regulator to the cylinder. Turn cylinder valve on slowly. Refer to Lighting Insructions.

 

 

 

 

 

 

SIDE BURNER IGNITION DOES NOT

Does burner light with a match?

If match lights burner, check igniter (see

WORK.

 

 

 

Sideburner Maintenance).

 

 

 

 

 

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.ducane.com.

19

Page 19
Image 19
Ducane 3200 owner manual Troubleshooting, Problem