OPERATIONS
| STANDBY/ | STANDBY/ON | BLANK |
STANDBY/ON Button | ON Button |
| LASER |
|
|
ENGLISH
POWER Indicator
VIDEORGB
Zoom Knob
Focus Ring
AUTO
MENUKEYSTONE
MENU SELECT
POSITIONRESET
FREEZE PinP
MAGNIFYMUTE
| OFF |
Power Switch | Lens Cap |
VOLUME |
Power ON
1.Check that the power cord is connected correctly.
2.Set the power switch to [ ]. The standby mode is selected, and the POWER indicator is turned to orange.
3.Press the STANDBY/ON button 
on the control panel or the remote control transmitter.
4.The POWER indicator ceases blinking and turns to green when power is on. Remove the lens cap.
5.Adjust picture size using the zoom knob.
6.Adjust focus using the focus ring .
Power OFF
1.Press the STANDBY/ON button 
on the control panel or the remote controller. Then,the message "Power off?" will appear on the screen, and the message will disappear by any operation
or no operation for 5 seconds. During this message indication, press the STANDBY/ON 
button again. The projector lamp is extinguished and lamp cooling begins. The POWER indicator
blinks orange during lamp cooling. Pressing the STANDBY/ON button 
has no effect while the POWER indicator is blinking.
2.The system assumes the Standby mode when cooling is complete, and the POWER indicator ceases blinking and changes to orange. Check that the indicator is orange and set the power switch to [O].
3.The POWER indicator is extinguished when power is off. Do not forget to attach the lens cap.
WARNING • Please read this manual, and the separate “SAFETY INSTRUCTIONS” thoroughly before using the equipment. Always ensure that
the equipment is used safely.
NOTE • Except in emergencies, follow the
•To prevent any trouble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a
•When a projector continues projecting the same image, the image may remain as an afterimage. Please do not project the image same for a long time.
