Using the remote control
The remote uses two (2) provided AA batteries. They are easily installed by sliding the cover off the remote’s back, aligning the + and - ends of the bat- teries, sliding them into place, and then replacing the cover.
To operate, point the remote at the projection screen or at the projector (not at the computer). The range of optimum operation is about 30 feet (9.14m).
Previous and Next buttons allow you to navigate through your PowerPoint presentation while in Slide Show mode. Connect the USB connector on the computer cable to your computer to use these buttons. When you do this for the first time, the Add New Hardware wizard may appear. See page 10 for details on loading the correct USB drivers.
Press the remote’s Menu button to open the projector’s menu system. Use the arrow buttons to navigate, and the Select button to select features and adjust values in the menus. See page 30 for more info on the menus.
The remote also has a Power button to turn the projector on and off (see page 16 for shutdown info), Volume and Mute buttons to control the sound, and a Source button to switch between sources.
Two
previous button | next button |
navigation buttons
Troubleshooting the remote
•Make sure the batteries are installed in the proper orientation and are not dead. The LED at the top of the remote lights when any button is pressed when the battery power is adequate.
•Make sure you’re pointing the remote at the projector, not the com- puter, and are within the remote range of 30 feet (9.14m).
•If you are trying to advance PowerPoint slides, make sure the USB por- tion of the M1 computer cable is connected and the correct drivers are installed.
26
