Dukane 8793h High Voltage, High Temperature, Replacing the lamp continued, High Pressure

Replacing the lamp (continued)

HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE

WARNING ►The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. In addition, if the bulb bursts, it is possible for shards of glass to fly into the lamp housing, and for gas containing mercury and dust containing fine particles of glass to escape from the projector’s vent holes.

►About disposal of a lamp: This product contains a mercury lamp; do not put it in a trash. Dispose of it in accordance with environmental laws.

•For lamp recycling, go to www.lamprecycle.org (in the US).

•For product disposal, consult your local government agency or www.eiae.org (in the US) or www.epsc.ca (in Canada).

For more information, ask your dealer.

• If the lamp should break (it will make a loud bang when it does), unplug the power cord from the outlet, and make sure to request a replacement lamp from your local dealer. Note that shards of glass could damage the projector’s internals, or cause injury during handling, so please do not try to clean the projector or replace the lamp yourself.

Disconnect • If the lamp should break (it will make a loud bang when it does),
the plug	ventilate the room well, and make sure not to inhale the gas or fine
from the	particles that come out from the projector's vent holes, and not to get
power	them into your eyes or mouth.

outlet	• Before replacing the lamp, turn the projector off and unplug the power
	cord, then wait at least 45 minutes for the lamp to cool sufficiently.
	Handling the lamp while hot can cause burns, as well as damaging the lamp.
	• Never unscrew except the appointed (marked by an arrow) screws.
	• Do not open the lamp cover while the projector is suspended from
	a ceiling. This is dangerous, since if the lamp’s bulb has broken, the
	shards will fall out when the cover is opened. In addition, working in
	high places is dangerous, so ask your local dealer to have the lamp
	replaced even if the bulb is not broken.
	• Do not use the projector with the lamp cover removed. At the lamp
	replacing, make sure that the screws are screwed in firmly. Loose
	screws could result in damage or injury.
	• Use only the lamp of the specified type. Use of a lamp that does not
	meet the lamp specifications for this model could cause a fire, damage or
	shorten the life of this product.
	• If the lamp breaks soon after the first time it is used, it is possible
	that there are electrical problems elsewhere besides the lamp. If this
	happens, consult your local dealer or a service representative.
	• Handle with care: jolting or scratching could cause the lamp bulb to burst during use.
	• Using the lamp for long periods of time, could cause it dark, not to light
	up or to burst. When the pictures appear dark, or when the color tone
	is poor, please replace the lamp as soon as possible. Do not use old
	(used) lamps; this is a cause of breakage.

14