Dukane AN400 manual Pin Number DPC Signal Name DPC Signal Type

DUKANE	- 2 -	Application Note
Intelligent Assembly Solutions		AN400

J602 User Interface Connector

The J602 User Interface connector is the primary communications link between the DPC IV and user automation equipment. This connector provides status signals that can be used to monitor DPC weld data analysis results as well as timing issues related to the processing of the weld sequence. It also provides the automation with dedicated communication lines that allows the automation to control the beginning and the end of a welding sequence.

	Pin Number	DPC Signal Name	DPC Signal Type
1		Power Supply	+22 VDC (0.5 amp max)
2		Ground	Power Supply Return
3		Bad Part	Output
4		Suspect Part (see note #2)	Output
5		Good Part	Output
6		Ready (see note #1)	Output
7		Isolated Output Common	Common Pin for Output Signals
8		Automation Input	Input
9		Automation Stop N/C	Input
10		Automation Stop N/O	Input
11		Hand Probe Press Inhibit	Input
12		Input Common	Common Pin for Input Signals
13		Ground	Power Supply Return
14
15		Ground Detect	Input

Note #1: This input can be reconfigured in the DPC IV menu choices to activate during the following weld sequence event:

In Cycle

Sonics On

In Hold

Note #2: This input can be reconfigured in the DPC IV menu choices to activate during the following weld sequence event:

Network Active

Sonics On

Note: Please refer to the Hardware Setup section of the DPC IV manual for details on reconfiguring pin 4 or pin 6 to the required status output signal.

Dukane Corporation

2900 Dukane Drive Saint Charles, IL 60174 USA

Phone (630) 797-4900 FAX (630) 797-494922102

http://www.dukane.com/us2

© Dukane Corporation 2004. All rights reserved.