Ready to Sync

7..Click on each of the tabs at the top (Apps, Music, Movies, TV shows, Books, Photos) and select which type of files you will want to sync on this device. Click the Sync or Apply button.

8..Repeat Steps 2 – 7 with each iPad that will be used in this cart.

Ready to Sync

1..When all the iPad devices have been configured, you are ready to charge and sync your tablets. Place each iPad in a slot in the cart. Plug each device in using the 30-pin Apple connector connectors. Plug the cart into a wall outlet.

2..If the iPad devices are new, they should be fully charged before attempting to sync.

3..When ready to sync, connect one end of the USB cable into the USB port near the auxiliary outlet and the other into a USB 2.0 port on your Mac or PC.

Safety

WARNING :

This cart must only be used for its intended purpose in accordance with these

operating instructions. Failure to observe the following notices can result in fire, injury, death by electric shock or equipment damage.

4. .iTunes will open and syncing will start automatically. Each iPad will be listed in iTunes under the Device list on the left hand side of the screen. You could review the sync status from master PC.

NOTE: Please keep in mind that identifying the devices and syncing will take time, so please be patient. The time is dependent on the number of iPads being synced and the amount of data being transferred. It can range from a few minutes to hours on 32 devices depends on different content. Please do not stop the process once it has been started.

5..When syncing is complete, the Eject symbol will appear next to each device. At this time it is safe to eject the device by clicking on the Eject symbol or closing iTunes.

6..When syncing is complete, unplug the USB Cable from your PC so charging can begin. Charging will not occur while the USB Cable is plugged into the master laptop.

iOS Updates

Due to the functionality of the iTunes software, iOS updates can not be done across the whole fleet of iPads at one time. This will need to be completed one unit at a time. It can still be done with the units plugged into the cart.

To update iOS on each iPad, select an iPad from under the Device list on the left side of the screen. Click on the Update button in the middle of the screen. Follow the prompts to complete the update. Updating time will vary depending on the size of the update from Apple. When one unit is complete, the next unit can be selected until all units have been updated.

ELECTRIC SHOCK

Operate Carefully

Always turn the cart power OFF before plugging the power cord into or removing from the wall outlet.

Make sure each devices is turned OFF before plugging into the cart. Do not unplug this cart from the outlet when your hands are wet.

Do not use cables that are damaged. Do not unplug by pulling on the cable.

Do not plug the power cord into an extension cable. Keep the door closed and locked when in use.

Disconnect the power cord from the wall outlet before opening the doors. Before moving this cart from one room to the next, wrap the power

cord around the winder located on the rear side of the cart.

This cart is not designed to be operated by a child or student. Only Adult operation and supervision should move this cart.

Do not allow anyone to set, stand, or climb on the cart. Move the cart slowly.

Keep the caster locked when the cart is not in transit. Keep the cart away from water.

Keep the ventilation holes unblocked for air circulation. Do not block the ventilation holes when charging.

Do not pull the cart. Push the cart using the ergonomic handles to prevent muscle strain.

Do not place a TV or monitor on top of the cart.

Do not use the cart to store liquids or cleaning supplies. Keep the door closed and locked when in use.

Disconnect the power cord from the wall before opening doors.

8

9

Page 5
Image 5
Dukane MCC2 manual Safety, Ready to Sync, iOS Updates