Duracraft DW-627 S Ta L L At I O N I N S T R U C T I O N S, U B L E H U N G W I N D O W S

I N S TA L L AT I O N I N S T R U C T I O N S

Your fan comes fully assembled and ready for installation. Casement and sliding windows require a mounting bracket for installation which can be found in the hard- ware packet provided.

Your window fan has been designed to fit double hung, casement or sliding windows with minimum openings of 56cm wide x 31cm high (217/8” x 12”). Casement or sliding windows require mini-

mum openings of 31cm wide x 56cm high (12” x 217/8”).

D O U B L E H U N G W I N D O W S

•Identify the front and back sides of the fan. The back side has plas- tic tabs at each corner. The front side has a “pull-out” handle near the top center.

•Open your window at least 28cm (11”) high.

•For FRESH AIR oper- ation, (draws in fresh air from the outside), hold the fan so the front side faces you.

•For EXHAUST opera-

tion (pulls indoor air out of the room), turn the fan so the back side faces you.

•Position the bottom of the fan in the window sill, making sure that the power cord is hang- ing inside your room.

•Hold the fan in place and lower the window to the top of the fan.

Be sure that contact is made with the window guides on the top of the fan (Fig. 1).

•To push the side pan- els back into the fan, pull out each plastic tab on the back side of the fan so that the metal part of the pull- out tab is hooked over the plastic ridge (Fig. 2). In this “pulled-out” posi- tion you can easily slide the side panels back into the fan. The tabs should then be returned to the normal position to secure the side panels in place.

FIG. 1 FIG. 2