Dymo M10, M25 manual Caring for the Scale, Using the Hold Feature, Changing the Units of Measure

Models: M25 M10

1 10
Download 10 pages 39.04 Kb
Page 5
Image 5
Using the Hold Feature

Using the Hold Feature

When an item being weighed extends over the front of the scale and you cannot see the display, you can freeze the display so that the weight is still displayed after removing the item.

To use the Hold feature

1.Press HOLD .

The LED flashes and the display shows HOLD, and then 0 g, 0.0 oz, or 0.00 oz when ready.

2.Place the item on the scale.

After a few seconds, the LED stops flashing and stays illuminated.

3.Remove the item from the scale.

The LED stays illuminated and the weight continues to be displayed for about ten seconds.

Changing the Units of Measure

Your scale can display weight in English (pounds) or metric (kilograms) units. The default unit of measure is English. Each time you turn on the scale, the scale defaults to the unit of measure that was last used.

To change the units of measure

Press

kg

lb

to toggle between English and metric units.

Caring for the Scale

With proper care and handling, your scale will give you years of service. Keep the following in mind when using your scale:

Your scale works best when operated and stored at normal room temperature. Avoid lengthy exposure to extreme heat or cold.

Only operate the scale on a stable, vibration free surface.

Exposure to dust, dirt, moisture, vibration, and air currents; and proximity to other electronic equipment can affect the reliability and accuracy of your scale.

Using the scale in proximity to wireless devices, such as mobile phones, can cause the scale display to fluctuate when the device is in use.

Although this scale is designed to be quite durable, gently place items to be weighed on the platform. Avoid rough treatment, as this may permanently damage the internal sensor and void your warranty.

You can permanently damage the scale by placing significantly overweight items on the scale platform.

Avoid shaking, dropping, or otherwise shocking the scale. This is a precision instrument and

MUST BE HANDLED WITH EXTREME CARE.

The scale has been calibrated at the factory and will not need to be calibrated again.

3

Page 5
Image 5
Dymo M10, M25 manual Caring for the Scale, Using the Hold Feature, Changing the Units of Measure, To use the Hold feature