Dynasty Spas 2008 manual Trouble Shooting Guide

TROUBLE SHOOTING GUIDE

No heat or heat too low

Probable Cause #1	Dirty Filter.
Action	Remove filter cartridge and clean.
Probable Cause #2	Breaker at house off.
Action	Reset breaker at house. Breaker can appear to be on
	and one pole can be off. Turn breaker OFF then ON
	twice.
Probable Cause #3	Pump not primed.
Action	Refer to the section of this manual on pump priming.
Probable Cause #4	Improper line voltage.
Action	Have a Licensed Electrician check the line voltage.
Spa Lights won't come on
Probable Cause #1	Light bulb burned out.
Action	Replace bulb (non-warranty).
Probable Cause #2	Dirty connection.
Action	Check to see if there is anything covering the
Pump will not prime	connection on the housing that holds the light bulb.
Probable Cause #1	No water in pump.
Action	Make sure water level in spa is correct.
Probable Cause #2	Closed gate valves or blocked lines.
Action	Open all gate valves. Check suction for blockage.
Probable Cause #3	Pump surges, jets lose and gain power, loose union
	or drain plug.
Action	Check union on front or nose of pump to ensure
Jet(s) won't come on	tightness. Check drain plugs to ensure tightness.
Probable Cause #1	Pump not primed.
Action	Refer to the section of this manual on pump priming.
Probable Cause #2	Gates valves closed.
Action	Check to see if gate valves are in the correct position.
	Check to see that pump is plugged in.
Probable Cause #3	Water Diverter Valve not adjusted correctly.
Action	Turn Water Diverter Valve until desired water flow is
	obtained.
Probably Cause #4	Individual jet is closed.
Action	Turn the outer jet housing clockwise to turn jet on.
Low water flow
Probable Cause #1	Dirty Filter.
Action	Remove filter cartridge and clean.
Probable Cause #2	Closed gate valves or blocked lines.
Action	Open all gate valves.
Probable Cause #3	Low voltage or incorrect voltage.
Action	Have a Licensed Electrician check the line voltage.

Dynasty Spas Operator’s Guide • www.dynastyspas.com 23