Operation
Front Out/ | ➊ ➋ LFE/SUB Out |
Pre Out |
|
LFE/SUB Out
Sub...
(Slave)
Front Out/
Pre Out
Sub 1 | Sub 2 |
(Master) | (Slave) |
Connecting a single subwoofer
➊To connect the SAT/SUB input:
XFrom the preamplifier output of your processor/receiver, PC or mediaplayer (often marked as Pre Out or Front Out) connect a stereo RCA cable to the subwoofer
SAT/SUB Input.
This signal should not be already processed by the processor/receiver. Please pay attention to the settings of your processor/receiver.
➋To connect the LFE channel:
XFrom the processor or receiver’s
This signal should not be already processed by the processor/receiver. Please pay attention to the settings of your processor/receiver.
XSet the MODE switch to LFE.
Note: You also can use both connection types. Both signals will be combined in the Sub 250 and routed accordingly. This allows the Sub 250 to reproduce both the LFE channel information as well as the bass range of the connected satellite speakers
Multiple subwoofer connections
The Dynaudio Sub 250 can be used
When using two or more subwoofers, the first one (designated “Master”) controls the following subs (designated “Slave”) via a subwoofer cable.
To connect multiple subwoofers:
1.Connect the first subwoofer with the processors/receiver as described before.
2.Set MODE switch of first subwoofer to LFE.
3.From the SUB I/O - LFE/To Slave output of the first subwoofer connect a mono
4.Set the MODE switch of the second subwoofer to Slave.
XFurther subwoofers can be connected in the same way. Set the MODE switch of all following subwoofers to Slave respectively.
Note: In order to avoid interference and noise, we recommend you use quality, well shielded cables.
When using multiple subwoofers in a
If you wish to use multiple subwoofers with full individual control, set the Input switch for all to the “Master” position. From the Amplifier, processor or receiver’s subwoofer output, use a
8 | Dynaudio Sub 250 |