Plastic clip

DX-CRDRD

All-in-One Internal Card Reader

QUICK SETUP GUIDE

Package contents

•Card reader with USB 5-pin cable
•Mounting screws (ISO 3f 4 mm) (4)
•Extra front bezel (1)
•Utility CD (includes AP drivers and User Guide)
•Quick Setup Guide

Minimum system requirements

•IBM-compatible PC
•CD drive
•One available on-board 5-pin USB connector on the computer’s system board
•One available 3.5-inch drive bay
•Windows® 7, Windows® Vista, Windows® XP, or Windows® 2000

Installing the card reader

Caution: Electrostatic discharge (static electricity) can damage electronic components. Make sure that you are grounded before you install your card reader. Turn off your computer, then touch a bare metal part of your computer, such as the back of the chassis or power supply, to discharge any static electricity.

To install your card reader:
1 Turn off your computer and disconnect the power cord.

2 Make sure that you are correctly grounded by touching a bare metal part of your computer, such as the back of the chassis or power supply.

3 Open your computer’s cover. For more information, see the documentation that came with your computer.

4 If you want the alternate colored bezel, change it now by pressing the four plastic clips on each side of the card reader with a pen or pencil and pulling the bezel off.

5Snap the new bezel into place.

6Make sure that your computer’s system board connector is compatible with your card reader’s USB connector.

Pin
Wire color
Function

P5

No contact

No contact

 

 

 

P4

Black/shield

Ground

 

 

 

P3

Green

D+

 

 

 

P2

White

D-

 

 

 

P1

Red
Vbus

 

 

 

7Carefully slide your card reader into the empty 3.5" drive bay.

8Secure your card reader to the drive bay with the four mounting screws (two screws per side).

9 Connect your card reader’s Screw

 

 

 

Screw

 

 

 

USB connector to a

 

 

 

 

compatible USB connector

 

 

 

 

on your computer’s systemboard.

 

 

 

 

(See illustration under Step 6.)

 

 

 

 

10Make sure that you have removed

any tools or loose screws from inside your computer, then replace your computer’s cover.

11Reconnect your computer’s power cord, then turn on your computer.

Using the card reader

To access a media card:

1Insert a card into the appropriate slot, as shown in the table on the next page.

Caution: Cards must be inserted into the correct slot and in the correct direction. Failure to do so may damage your card and card reader.

2Open My Computer or Windows Explorer, then double-click the drive icon for the slot you are using.

3To access files and folders on the inserted card, use normal Windows procedures for opening, copying, pasting, or deleting files and folders.

4When you have finished working with the files on a memory card, right-click the memory card icon in My Computer or Windows Explorer and click Eject. The R/W LED on the memory card reader turns off when the card is removed.

Caution: Do not remove memory cards while the data R/W (read/write) LED on the reader is flashing.

Understanding the LED indicator

The R/W LED indicates when a slot is reading from or writing to a card.

•LED off—Your card reader is not being used.
•LED on—A card is inserted in one of the slots.
•LED flashing—Data is being transferred to or from a card.