8Using the charger
Mounting the battery into the charger
Warning: For use with Lithium-Ion (Li-ion) batteries only. Do not attempt to
charge Nickel Cadmium (Ni-Cd) or Nickel Metal Hydride (Ni-MH) batter ies.
To mount the battery into the charger:
1Note where the guides and contacts are located on the battery and align
them with the corresponding guides and contacts on the charger, then slide
the battery into place in the charging bay.
2Press the battery down, then slide it up (away from the indicator lights).
- OR -
Slide the battery up, then press it down (depending on the battery to be
charged).
Do not force the battery onto the charger. If it does not slide easily into the
guides, re-align it and try again.
USING AN ADAPTER TRAY
Depending on your battery type, you may need to use an adapter tray. Refer to the
Battery Compatibility List to determine which adapter tray should be us ed with
your battery type.
To install the adapter tray onto the charger:
1Slide the central notch on the adapter tray’s upper edge into the slot on the
upper edge of the charger bay, then carefully press down on the lower edge
of the adapter tray.
The adapter tray snaps firmly in place. Install the battery so that its conta cts
meet the contacts on the adapter tray.
2To remove the adapter tray, pull back on the battery/adapter latch, then lift
the adapter tray up and out of the charger.
USING THE UNIVERSAL ADAPTER PLATE
The universal adapter plate label provides only a partial list of batteries that are
compatible with this charger plate. Refer to the Battery Compatibility List for the
entire make and model list of compatible batteries.
Dynex DX-DA100501 camcorder battery charger - combined.fm Page 8 Friday, October 28, 2005 2:54 PM