Dynex DX-DPF7-10-MX

Setting up your digital picture frame 9

Warning: There is a danger of explosion if the battery is not

replaced correctly. Replace with the same or equivalent type

battery.

To install a remote control battery:

1Turn the remote control over to the back side.

2Push the release tab to the right and pull the battery tray

out of the remote control.

3If this is the first time you will be using the remote control,

remove the insulation sheet that covers the battery.

-OR-

If you are replacing the battery, remove the old battery and

insert a new lithium coin cell battery (CR2025) into the

battery tray. Make sure that you match the + symbol on

the battery with the + symbol on the battery tray.

10-0796 DX_DPF7-10_MAN_ENG_V2.fm Page 9 Thursday, July 29, 2010 7:18 AM

Contents

Main 7 Digital Picture Frame Contents Introduction Important safety instructions Page 4 Features Package contents: Controls and connections Page 6 Page Setting up your digital picture frame Installing the remote control battery Page 4Slide the battery tray back into the remote control until it clicks into place. Making connections Positioning your digital picture frame Configuring your digital picture frame Page Using your digital picture frame Starting a picture slideshow 16 Copying and deleting pictures Troubleshooting 18 Specifications Legal notices 20 Legal notices 21 90-day limited warranty How long does the coverage last? What does this warranty cover? How to obtain warranty service? 22 Where is the warranty valid? What does the warranty not cover?