Dynex DX-LCD32 Using your TV, •Video1 (composite rear), •Video2 (S-Videorear), •Video3 (composite side), •Video4 (S-Videoside), •Video5 (component1), •Video6 (component2)

Using your TV

Using your TV

Turning your TV on and off

To turn your TV on and off:

1Make sure that the power cord is connected to your TV and a power outlet.

2Press the button to turn on your TV. The power indicator LED turns green.

3Press the button again to return your TV to standby. The power indicator LED turns orange.

Selecting the TV signal source

To select the TV signal source:

•With the TV on, press the INPUT button on either the TV or the remote to choose from: ANT (antenna)

•Video1 (composite rear)

•Video2 (S-Video rear)

•Video3 (composite side)

•Video4 (S-Video side)

•Video5 (component1)

•Video6 (component2)

•Video7 (VGA)

•Video8 (HDMI1)

•Video9 (HDMI2)

If you select Video1, press the VIDEO button to choose between composite and S-Video.

Note

HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.

Setting up the channel list

After you select your TV source, if you selected antenna or cable you need to set up the channel list. When you set up your channel list, your TV searches for all available channels in your area and stores a list of these channels. When you press the CH – or CH + buttons, your TV skips the channels that do not have a signal.

Automatically setting up channels

To automatically set up the channel list:

1Press the MENU button. The Main on-screen display menu opens with Setup highlighted.

ENTER

2Press the button to enter the sub-menu, then or button to highlight Auto Ch Search.

3Press ENTER or to start the search.

Note

You can press the Exit button to stop the search.

7

Manually adding or deleting channels from the channel list

After you create a channel list using the Auto Ch Search option, you can manually add or delete channels from the channel list.

To add or delete channels:

1Press the MENU button. The Main OSD (On-Screen Display) menu opens with Setup highlighted.

2Press the button to enter the sub-menu, then or to highlight Manual Channel Set. The Channel Setup Table opens.

3Press the or button to select a channel, then press then press ENTER to toggle between viewable and not viewable.

4Press MENU or EXIT to close the menu.

Changing channels

To change channels:

•Press the CH – or CH + button on the remote control to go to the next lower or higher channel.

- OR -

Press the number buttons to directly select a channel (for example, if you want channel 83, press 8, then press 3).

- OR -

Press the RECALL button to go to the last viewed channel.

Selecting a digital sub-channel

Most digital TV channels have more than one channel. The main channel carries the signal for the main TV program. The sub-channels carry signals for additional or alternate programming, such as a radio or news broadcast.

For example, if the main channel number is 8, the sub-channel number might be 8-1, 8-2, or 8-3.

To select a sub-channel:

1Press the number buttons for the main channel (for example 8).

2Press the – button, then press the sub-channel button (for example 1).

Adjusting the volume

To adjust the volume:

•Press the VOL – or VOL + button to decrease or increase the volume.

•Press the MUTE button to turn off the sound. Press the MUTE button again to turn the sound back on.

Displaying status information

To display status information:

•Press the DISPLAY button. Your TV displays status information, such as the channel number or signal source.

Checking the DTV signal strength

To check the DTV signal strength:

1Press the MENU button. The Main OSD (On-Screen Display) menu opens with Setup highlighted.