Dynex DX-LCD37-09-2 Setting up your TV, Installing remote control batteries, Attaching the stand, To install remote control batteries:, To attach the stand:

Setting up your TV

Installing remote control batteries

To install remote control batteries:

1Open the battery compartment cover.

2Insert two AAA batteries into the battery compartment. Make sure that the + and – symbols on the batteries match the + and

– symbols in the battery compartment.

3Replace the cover.

Notes:

•Do not mix different types of batteries.

•Do not mix old and new batteries.

•Remove batteries when they no longer have a charge. Chemicals may leak into the battery compartment. Battery chemicals can cause a rash. If chemicals leak, clean the battery compartment with a cloth.

•Remove the batteries if you do not intend to use the remote control for an extended amount of time.

•Do not dispose of batteries in a fire. Dispose of them as hazardous waste.

Attaching the stand

Note: Your TV may look different than the illustrations in this procedure.

If you plan to set your TV on a flat surface, such as a table or cabinet, you must install the stand.

Cautions:

•Make sure that you handle your TV carefully when installing or removing the stand. If you are not sure comfortable with this procedure or you do not know how to use the tools required to complete this procedure, contact a professional installer or service personnel. Dynex is not responsible for any damages or injuries that may occur because of mishandling or incorrect assembly.

•When you lay your TV face down, make sure that you place is on a soft cushion or covering to prevent damage to the screen or case.

•The speaker is not intended to support the weight of your TV. Do not use the speaker as a handle for moving your TV because you may damage your TV. This type of damage is not covered by your warranty.

•Before you attach or remove the stand, make sure that the power cord is unplugged.

To attach the stand:

1Remove the stand from the box and place it on a table or work bench.

2Lay your TV face down on the edge of the table or work bench.

Caution: Make sure that you place your TV on a soft cushion or covering to prevent damage to the screen or case.

Stand

Table edge

Stand column

3Align the holes on the stand with the holes in the stand column and align the locating groove in the stand with the locator in the stand column. Make sure that the locater is fully inserted into the locating groove, or your TV may be unstable and tip over.

Locator

Locator groove

4Secure the stand to the column with the four M5 screws (provided).

5Place your TV upright.