12

DX-32L151A11/DX-37L130A11

Understanding the basics

9Press or to select Home Mode or Retail Mode, then press

ENTER.

If you select Home Mode, the Choose your TV source screen opens.

-OR-

If you select Retail Mode, a message stating “Are you sure you want Retail mode? Since in this mode Energy saving is not realized.” appears. Select Yes to proceed, or No to exit.

10Press or to select Antenna, Cable, or Cable/Satellite Box, depending on the type of connection you have.

•If you are using an antenna for a standard or HD TV signal, select Antenna.

•If your cable is connected directly to the TV (without a tuner box), select Cable.

•If your cable is connected to your TV through a tuner box, select Cable/Satellite Box.

11Press when you have made your selection. The channel scan screen opens.

If you selected Antenna or Cable, your TV automatically scans for available channels in your area and stores the channel information in the channel list. This may take several minutes. While scanning, the TV displays a progress report.

– OR –

If you selected Cable/Satellite Box, the auto scan is not necessary and the screen will ask you to select the correct input source for your set top box. Press EXIT to close the menu.

Notes:

•During auto scan, digital programs will be scanned first, then analog programs. When all available digital programs have been searched, the screen will ask you to “Press MENU or EXIT if you don’t need analog channel scan.” At this point you can press EXIT to exit the analog channel scan, or just ignore it and the TV will go on scanning.

•Channel scan can take up to 30+ minutes.

•You can press EXIT at any time to stop the auto scan, but you will need to run the auto scan again to create a channel list.

12Select the corresponding video input source through the INPUT SOURCE menu.

Understanding the basics

Turning your TV on or off

To turn your TV on or off (standby mode):

1Plug the power cord into an AC power outlet.

2 Press (power). Your TV turns on.

3Press again to turn off your TV. When you turn off your TV, it goes into standby mode.

Warning: When your TV is in standby mode, it is still receiving power. To completely disconnect power, unplug the power cord.

Note: If your TV does not receive an input signal for several minutes, it automatically goes into standby mode.

Selecting the video input source

To select the video input source:

1Turn on your TV, then press the INPUT key on the remote, or the INPUT button on the TV. The INPUT SOURCE menu opens.

INPUT SOURCE

TV

AV

Component
HDMI1
HDMI2
VGA

2Pressor to highlight the video source, then press ENTER. You can also select the input source using the following remote control buttons:

•VIDEO—Press switch to AV input.

•HDMI–Press repeatedly to cycle between HDMI inputs.

•TV—Press to switch to TV mode.

•COMP—Press to switch to Component input.

Selecting a channel

To select a channel:

•Press CH / CH to go to the next or previous channel.

•Press the number buttons to enter the channel number you want, then wait for the channel to change, or press ENTER to change the channel immediately.

•To select a digital channel, press the number buttons to select the main digital channel, then press the dot (.) button, then the number buttons again to select the sub-channel. Wait for the channel to change or press ENTER to change the channel.

Note: Button presses must be within three seconds of each other.

•Press RECALL to go to the last channel viewed.

•Press CH-LISTto display a list of memorized channels, pressor to select the channel you want from the list, then press ENTER to go to that channel.

•Press FAVORITE to display a list of your saved favorite channels,

press or to select the channel you want from the list, then press ENTER to go to that channel.