4

DX-32L151A11/DX-37L130A11

Installing the stand or removing the stand column

Installing the stand or removing the stand column

Cautions

•Read these instructions carefully before you try to assemble the stand or remove the stand column.

•Make sure that you handle the TV carefully when attempting to assemble or remove the stand. If you are not sure of your ability to do this, contact a professional installer or service technician. Dynex is not responsible for any damages or injuries that occur because of mishandling or incorrect assembly.

•Use a soft cushion or covering to prevent scratching or damage to the TV screen or cabinet.

•The speaker is not intended to support the weight of the TV. Do not move or handle the TV by the speaker. This can cause damage that is not covered by your warranty.

•Before assembly or removal of the stand, unplug the power cord. You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to mount your TV on a wall or other vertical surface, you must remove the stand column.

Installing the stand

You must install the stand to use the TV in an upright position on a flat surface.

Note: Your TV may differ from the illustrations shown.

To install the stand:

1Remove the stand from the box and place it on a table or bench.

2Lay the TV (screen down) on the edge of the table or bench. Make sure that you put a soft cloth or cushion between the table or bench and the TV.

Table edge

Stand

Stand column

3Align the locators on the stand column with the locating holes on the stand, then secure the stand to the column with the four M5 screws (provided).

Locators

Locating holes

Table edge

Stand

4Carefully lift the TV into an upright position.

To remove the stand, perform these steps in reverse order.

Removing the stand column

You must remove the stand column before you can wall-mount the TV.

Note: Your TV may differ from the illustrations shown.

To remove the stand column:

1Lay the TV (screen down) on the edge of the table or bench. Make sure that you put a soft cloth or cushion between the table or bench and the TV.

2Remove the four screws holding the stand column to the TV, then remove the stand column.

Stand column

Installing a wall-mount bracket

If you want to attach the TV to a wall-mount bracket (not provided), you should first remove the stand pedestal, if it is already attached.

To install a wall-mount bracket:

1Lay your TV face down on a table or bench. Make sure that you put down a soft cushion or cloth so that your TV is not scratched.

2Remove the pedestal stand.

3Remove the stand column. See “Removing the stand column” on page 4.

4Secure the wall-mount bracket to the back of your TV using the four M6 screws provided with the bracket.

TV components

Accessories

Make sure the following accessories are included in the box with your TV:

•Remote control

•Composite video & audio cable

•AC power cord

•AAA batteries (2)

•Stand

•Quick Start Guide

Four M5 screws