Dyson DC02 Changing filters, Automatic suction control trigger, Clear bin full mark, Cord rewind

1

2

IMPORTANT Use only genuine Dyson filters.

Changing filters

Your DCO2 is fitted with two high area H-level electrostatic cartridge filters. Alternatively a standard S-level filter may be purchased.

1 Insert top filter ensuring that it fits snugly against the black rubber seal on the machine.

2Slide rear filter into the grooves and push it down fully.

Fitting instructions for the standard S-level filters are printed on the filter itself.

2

H S

H-LevelS-Level

2 H-level O R 1 S-level

Automatic suction control trigger

Hold the yellow trigger down to reduce suction for upholstery and curtains.

To maintain reduced suction, press the trigger down hard until it clicks. To unlock and resume full suction, press down the opposite end of the trigger.

m	max
a
x

Clear bin full mark

Note: Do not fill above this line.

2. Clear bin removal

Sits securely on the stairs

However, always work above the machine on stairs for your own safety.

The plug is situated underneath the tool cover on the right hand side.

On/off switch

Press left switch.

Cord rewind

Press right switch for cord rewind.

click

1

1.Hose & wand assembly

Assemble hose and wand by fitting together at joints 1∂ , ∑2 , and ∏3 . Push yellow cuffs in until both buttons ‘click’ into place.

Press buttons and pull hose to release.

Tool storage

Press yellow release catch to open the tool storage cover and insert required tool into end of wand or wand handle. Please note that tools may feel warm when machine has been running; this is perfectly normal.

WandWand handle

W A R N I N G ! For your own safety please remember to unplug the machine when not in use and before carrying out maintenance.

	Telescopic wand
3	Press yellow button and
	slide wand down to

adjust length.

Self adjusting

Floor tool

Fit floor tool by pushing firmly into end of wand.

Height adjustment

Use selector to adjust to hard floor or carpet. Forward for carpets and back for smooth floors.

Blockage procedure

Please note: Any ‘Blockage only’ repairs will incur a charge of £35.00*. Please check your machine carefully.

Check filters, replace if older than 3 months, or if filters are heavily coated with dust.

*Price correct at time of printing.

1. Check entry swivel ∂1 by 1

pressing yellow buttons & pulling out hose.

Clear any debris.

22. Check wand handle swivel 2

	by pressing yellow buttons and
	pulling hose from wand. Clear
	any debris.
3. Check wand joint 3	3
by pulling wand
and wand handle
apart. Clear any blockage
with rod or wire.
4
	4. Remove floor tool from
	wand π4 and check for
	blockage.

5.Check air intake hole and check ramp.

1To empty clear bin, pull back release catch under carrying handle and raise top of machine.

2 Lift clear bin out of machine. 3 Remove cyclone top (lid).

4 Wrap a plastic bag	5 Invert clear bin and wait at least
tightly around the rim	10 seconds before releasing.
of the clear bin.
	OPTIONAL

6 Wipe shroud holes	7 Do not use strong
free of all dust/debris.	detergents and ensure
	clear bin is fully dry before
	replacing in machine.
	Note: The yellow bin inner
click	should not be removed from
	the bin when it is cleaned.
	8 Replace clear bin and cyclone
	top and close machine.
	Ensure release catch
	‘clicks’ into position before
	using the vacuum cleaner or
	lifting the machine by the
	carrying handle.