![](/images/new-backgrounds/1228844/22884425x1.webp)
If the transducer's face isn't parallel with the ground, remove the transducer and ratchets from the bracket. Place the ratchets into the holes in the bracket with the letter "B" aligned with the dot stamped in the bracket.
Reassemble the transducer and bracket and place them against the transom. Again, check to see if you can move the transducer so it's par- allel with the ground. If you can, then go to step 3A.
3.Assembling the transducer.
A.
Position transducer mount on transom and mark mounting holes. Side
view shown, left, and seen from above at right.
7