Eagle Electronics EGA200 Before Using this AIR Tool, Operating Instructions, Troubleshooting

BEFORE USING THIS AIR TOOL

To ensure long life be sure to oil the tool daily. Pour 4 drops of Eagle air tool (SEA 20 non detergent) oil into the air inlet, and then run the tool for a few seconds to clean.

If tool is an impact wrench fitted with a “Zirc” grease fitting:

The hammer mechanism of this tool also needs to be greased from time to time (depending on usage). The tool is equipped with grease fitting for this purpose; use this connection to re-grease the tool using Eagle impact wrench grease.

PLEASE USE EAGLE SEA 20 NON DETERGENT OIL

OPERATING INSTRUCTIONS

This ratchet is designed to speed up productivity, not for high torque applications such as head bolts, lug nuts, etc. DO NOT USE THIS RATCHET UNDER POWER TO BREAK FASTENERS LOOSE. Loosen fasteners by hand without depressing throttle. Once loose depress throttle. Always perform final torque tightening by hand.

This ratchet is rated to 3/8” bolt size. Rating will decrease for U-bolts, long cap screws, spring fasteners and rusted or corroded fasteners. All these factors absorb power and reduce torque capability.

Use the simplest socket to wrench hook-up. Any additional extensions, U-joints or adapters will absorb power and reduce torque capability.

Forward/Reverse Lever - Select “F” for forward (clockwise) or “R” for reverse (counter clockwise) opera- tion. Do not attempt to change direction while tool is running.

If fastener bogs, slows or binds the tool (or, if the fastener fails to move in 5 seconds), use a large size impact wrench with a higher torque rating. Overloading this tool will cause premature wear and/or per- manent damage to internal and external drive parts and will void warranty.

TROUBLESHOOTING

SYMPTOMS	CAUSE	REMEDY
Air tool does not	Lack of lubrication.	Lubricate as per instructions.
run or runs slow.
	Dirt in tool.	Clean with mixture of 50/50 tool
		oil/solvent. Lubricate after cleaning.
	Insufficient air pressure.	Check regulator and air supply for
		leaks. Check compressor to make
		sure it operates at correct pressure.
		Make sure air hose is properly sized
		and that multiple hoses are not
		connected to same outlet. Check air
		hose for leaks and repair.
	Rotor blades worn or motor	Replace blades, inspect clean or
	bearing worn or dirty.	replace bearing.
IMPACT WRENCH	See causes (above).	See remedies (above).
does not impact or
impacts slowly.
	Broken or worn impact	Inspect and repair as required.
	mechanism.

Wear hearing protection.

Wear eye protection.

Wear respiratory protection.

Read the instruction manual