Eagle Electronics EHR-10 Before Using your Radio, Charging and Installing the Ni-MH Battery Pack

Before Using your Radio

Before using your radio, you should make the following preparations:

Carefully inspect the package contents for: the radio, battery pack, antenna, AC/DC wall charger, wrist strap, belt clip, and this manual (including product warranty).

1.Fully charge the Ni-MH battery pack for a minimum 14 - 16 hours and install it onto the radio.

2.Install the antenna onto the radio.

3.Install the belt clip onto the radio.

1.Charging and Installing the Ni-MH Battery Pack

Install the Ni-MH battery pack onto the radio:

Use a coin or screwdriver rotate the screw lock clockwise to lock the battery pack onto the radio.

1. Plug in the AC/DC wall charger - check the voltage is correct for your wall charger.

2. Connect the charging wire into the charging socket on the base of the Ni-MH battery.

3. The red LED should light indicating the charger is connected. Charge for a minimum 14 - 16 hours - do not over-charge.

EAGLE EHR-10Operation Instructions 7