3
INTRODUCTION
The Earlex HV7000 “Spray Port” is an industrially rated, portable, paint spraying system and is intended for
useby professionals. HVLP stands for High Volume, Low Pressure. This is a type of spraying that allows you
to spray extremely accurately but without all the overspray that occurs with high pressure tank equipment. In
some parts of the world the high pressure systems are banned by law on environmental grounds and HVLP
typesystems are the only alternative for professional type spraying. This system is extremely easy to use, very
safeand reduces the amount of paint used.
TheEarlex Spray Port (model no. HV7000UK110PD, HV7000UK110H, HV7000UK230PD & HV7000UK230H)
isa portable system that is made up as a trolley unit that can be broken down into two separate parts, the main
TurbineUnit and the Carrier Stand. Thesetwo parts connect together via two quick release clips allowing the
complete system to be wheeled from a vehicle to the workplace or around the workshop. They are easily
separatedso they can be stored in the back of a van or truck. The Carrier Stand holds the Air Hose and spray
applicator and also has space for a cleaning kit. The Earlex Spray Port (model no.HV7000UK110NF &
HV7000UK230NF)is supplied with the main turbine unit, hose and gun. Your Spray Port can be supplied with
a plastic spray applicator Type P or,an aluminium spray applicator Type A. Both types will give identical
excellentresults.
PLEASE NOTE: Wehave done all we can to ensure that used correctly and according to these instructions,
thisspray applicator will give long and trouble free life. We accept no responsibility for damage caused by the
use of incorrect or unsuitable substances, paints or fluids which have not been thinned correctly or are
unsuitable for the surfaces to which they are applied, health hazards arising from lack of ventilation when
workingin confinedspaces orfailure ofthe equipmentdue toinadequate cleaningof thecomponents afteruse.
Ifin doubt, always test a small inconspicuous area first. Always read the paint manufacturer’s instructions first.
Neitherour guarantee nor the above statement affects your statutory rights.
IMPORTANT BASIC INFORMATION
SELECTINGPAINT
This is a highly versatile spray kit that can be used with several differentspray mediums including varnishes,
wood preservatives, enamels, oil and water based paints and cellulose. However some materials cannot be
sprayedso please check the recommendation of the manufacturer before buying the paint. If a material refers
tobrush application only then it usually cannot be sprayed.
THISUNIT SHOULD NOT BE USED FOR TEXTURED PAINTS. THESE MATERIALS CONTAINPARTICLES
OFGRIT THAT WILL CAUSE PREMATURE AND EXCESSIVE WEAR. USE OF SUCH MATERIALS WILL
INVALIDATETHE GUARANTEE. TO OBTAIN THE BEST RESULTS FROM YOUR SPRAY KIT PLEASE
READTHE INSTRUCTIONS CAREFULLY BEFORE USE.
SURFACEPREPARATION
Preparationof the surface and thinning of the paint are the two most important areas to be concerned with to
obtain the best results from your spray kit. Ensure all surfaces are free from dust, dirt, rust and grease. If
necessarysmooth with sandpaper, or similar. Masking of areas is important to ensure you do not spray those
areasyou wish to remain untouched.
THINNING
Yourspray kit is supplied with a viscosity cup. Viscosity is a technical term used to indicate if a product is very
thinor very thick. If thin, the viscosity is said to be low, while if very thick the viscosity is said to be high.
Viscosityis measured in seconds. In order to spray some materials they need to be “thinned” (diluted).
Thinningis very important when spraying. Most paints are supplied ready for brush application and may need
tobe thinned (diluted) for spraying purposes.
Follow the manufacturers guide for thinning in conjunction with a spray applicator.If in doubt please contact
themanufacturers of the paint. The viscosity cup supplied will help you determine the correct thickness of the
paint. Paint is “thinned” by adding the substance which the paint is based upon. If a water based paint then
wateris added, if oil based then white spirit, if automotive coating then an automotive coating thinner is added.
As some paints, wood preservatives and other sprayable materials contain particles that have differing
qualities, please ensure that when filling the paint container of the spray applicator, that the paint is filtered
through either a funnel with a filter on it or through nylon tights or stockings. This will ensure that no large
particles enter the paint container, so preventing blockages and providing you with trouble free spraying.
Ensurethat a face mask, gloves and goggles are worn at all times when spraying.