Earlex SC77 manual Trouble shootIng, MaIns connectIon, Guarantee, Patents, Design registration nos

trouble shootIng

IF A PROBLEM OCCURS ALWAYS SWITCH THE UNIT OFF IMMEDIATELY.

problem		cause	actIon
Unit fails to boil.		Safety cut-out has	Refill boiler making sure to cover the element;
		operated.	allow unit to cool for 20 mins then re-try.
		Fuse has blown in lead.	Replace with a 13 amp fuse only.
		Power cord extension	Extension cables must be rated at at least 10
		being used.	amps and fully unwound. A lower rating will trip out.
		Element burnt out due	The element cannot be replaced, you can buy a
		to tilting of unit in use or a	replacement boiler from our Service Department.
		chemical used in boiler.
Unit leaks from Pressure		Dirty seal.	Unplug the unit and allow to cool. Clean seal and
Relief valve.			surface it sits on.
		Blockage/kink in hose.	Allow unit to cool then remove hose and check for
			blockages.
		Blockage in inlet of tool.	When unit is cool check for obstruction in inlet.
	If you requIre further assIstance please contact our helplIne on
		tel: 01483 454666 fax: 01483 454548	email: enquiries@earlex.co.uk
	opening hours: monday - thursday 08:30 - 17:00, friday 08:30 - 15:45 (except bank holidays)

maIns connectIon

Your unit has been supplied with a mains lead with a fitted plug. This is identified by the fuse holder in the base of the plug. Please read the following safety instructions before use.

1 If the fitted plug is cut off from the mains lead then the plug must be disposed of safely. never under any circumstances insert such a plug into a 13 amp socket.

2 never under any circumstances use the appliance or mains lead without the fuse cover fitted. This is the little cover fixed into the base of plug to hold the fuse in place.

3 If you lose the fuse cover then please contact any electrical dealer for a replacement or ring our helpline.

4 A replacement fuse must be rated at 13 amp. These must be manufactured and approved to BS 1362.

5 If In any doubt please consult a qualIfIed electrIcIan.

If you need to fit a plug to the mains lead, this should be fitted in accordance with the wiring instructions below, and will need to be used with a 13 amp fuse. If in any doubt consult a qualified electrician.

warnIng - thIs applIance must be earthed. If you are using an extension lead it must be rated at a minimum of 10 amps and fully unwound. Do not operate with a lead rated less than 10 amps as this will cause premature failure of the element which is not covered by the guarantee.

As the colours of the wires in the mains Iead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol, or coloured green or green and yellow.

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

InformatIon on the dIsposal of waste electrIcal and electronIc equIpment Known as weee

Your attention is brought to new directives applicable to the disposal of this electrical equipment, where in accordance with the legislation this product must not be disposed of in your normal household waste. Instead it is your responsibility to dispose of this type of waste by handing it over to special designated collection points for recovery and recycling. This product is marked with a ‘Wheelie bin’ symbol with a cross on it to remind you of this action. The objective of this directive is to help conserve resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste please contact your local authority, take back facilities are free of charge.

guarantee

This product is guaranteed for a period of 24 months against faulty materials and workmanship. Whilst every possible care is taken by Earlex to ensure that our products leave the factory in good working order, Earlex cannot under any circumstances accept liability for problems or damage caused by their subsequent use. It is the responsibility of the user to ensure that surfaces to be treated, cleaned or stripped are suitable for steam.This guarantee does not affect your statutory rights. This guarantee excludes the use for hire purposes. In the event of a fault occuring please contact our helpline before returning the unit to our Service Department at the address below together with a copy of your purchase receipt. All repairs will be dealt with speedily.

ec declaration of conformity

We declare that the units: SC75, SC76, SC77, SC125, & SC165 conform to: LVD 2006/95/EC, EN 60335-2-54, EN 60335-1; EMF EN 62233; EMC Directive 2004/108/EC, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3

Tim Hopper -Technical Director

patents:

GB 2294515, GB 2300698, GB 2 422 731, DE 19539236.1, DE 29522026

design registration nos:

GB3004739, DE 40205274.9, FR 02 4020, GB 1059125, US D496, 504S

Earlex Ltd. Moorfield Road, Guildford, Surrey, GU1 1SZ, United Kingdom.

Tel: +44 (0) 1483 454666. Fax: +44 (0) 1483 454548. email: enquiries@earlex.co.uk Website: www.earlex.com

© 2011 Earlex Ltd. AC309 10/11

8