Earthquake Sound Cinenova 7 Getting Started with the Cinénova Grande, Speaker Connections

Pre-setup with Cinénova Grande

Earthquake Sound

Getting Started with the Cinénova Grande

1) INPUT SELECTION 2) X-OVER MODE SELECTION

Confirm the voltage setting of the amplifier. It must match the voltage in your home. The amp is set by factory to either 120V or 240V. Check above the circuit breaker for this information.

Amplification Block Plate Power Plate

4

Set the input control to either RCA or XLR.

This tells the amp which input type will be

used.

The Cinénova Grande houses 5 or 7 amplification blocks. Each block comes with a 3-way Mode Selection switch. Generally the amplifier Is used in By Pass mode and fed a crossed signal from a processor. Unless otherwise desired, the crossover switch should remain in Bypass position.

1

2 6

3) SPEAKER CONNECTIONS				4) 12VDC WHEN APPLICABLE
A pair of binding posts is				If you plan to power the
p r o v i d e d f o r e a c h				Cinénova using	an
channel. These posts				external source,	then
accept bare wire, spade				you will need to plug the
lugs	&	banana type		source into the 12VDC
plugs.	If	bare wire is		Trigger.
u s e d t h e n , s t r i p
approximately 1/2 inch				When using this feature
to 3/4 inch of insulation				the main power switch
from the end of each				must remain in the OFF
wire and carefully twist				position at all times.
the strands			of each
conductor			together.
Then insert.
5) PLUG IN POWER CORD				6) TURN ON CIRCUIT BREAKER

5

3

Plug the AC power cord into the amp first then into the wall outlet. Make sure it is firmly connected.

This amp is equipped with a 20 ampere circuit breaker. Once that all tasks have completed then proceed to turn the circuit breaker to the on position.

6