SPECIFICATIONS
| Actual RMS power varies based on box design and on music played |
SWS Enclosures
SWS subwoofers are designed to bring bass virtually anywhere in a car: in front doors, rear doors, dash board, center console, under seats, rear decks, and in any space limited
•Speaker diameter = 15"
•Mounting depth = 3 1/4"
•Cut out mounting hole = 13 3/4"
•Weight = 15Lbs
•Voice Coil diameter = 2.5"
•Aluminum bobbin / wire
•Power rating RMS = 400W
•Power rating MAX = 800W
•Revc = 3.76 Ohms
(350mm / 13 3/4")
(cut out hole diameter)
(81mm) (3 1/4")
mounting depth. The following volumes shown below are created to give you optimized "deep bass from the shallowest space".
In order to match a box volume that bests suites your needs, you will need to find out the amount of space that you have to work with, then use the formula below to find out which range you will should be in based on our recommendations.
Choosing an enclosure type that perfectly tailors to your needs can sometimes be a hassle and unfortunately choosing or building the wrong enclosure could potentially destroy the sound quality of your system. The SWS subwoofers deliver truly prenominal bass response
| Actual RMS power varies based on box design and on music played |
from the shallowest of places. And in order to harness their greatness you will need to make sure that your enclosure will be suffice for your application.
•Speaker diameter = 12"
•Mounting depth = 3"
•Cut out mounting hole = 11 3/8"
•Weight = 13Lbs
•Voice Coil diameter = 2.5"
•Aluminum bobbin
•Power rating RMS = 300W
•Power rating MAX = 600W
•Revc = 3.76 Ohms
(288mm / 11 3/8")
(cut out hole diameter)
(75mm)
(3")
Sealed Enclosures:
Do you often turn the bass down on a car or home stereo system because it sounds boomy to you? If you do, a sealed enclosure is an excellent choice, especially if you listen to a wide variety of music. This type of enclosure produces
Bandpass Enclosures:
This bass is not really punchy, it's more like a massive, swampy force of low end that powers the music which can be great for some tunes and extremely overwhelming on
•Speaker diameter = 10"
•Mounting depth = 2 11/16"
•Cut out mounting hole = 9"
•Weight = 11Lbs
•Voice Coil diameter = 2"
•Aluminum bobbin
•Power rating RMS = 200W
•Power rating MAX = 400W
•Revc = 3.76 Ohms
Actual RMS power varies based on box design and on music played
(68mm)
(2 11/16")
(228mm / 9")
(cut out hole diameter)
others. If you prefer the harder stuff (metal, hard rock, industrial) or music with impact bass content (reggae, hip hop) and you like your bass to be LOUD, the bandpass box is a great way to go. And, if your amplifier is lacking in the power department, you'll get the most bang for your buck from this design.
Ported Enclosure:
The ported box is also exceptionally loud, so it will also be a good choice if you have limited power available. If you listen to a wide range of music and if you're always cranking up the bass when you listen to tunes.
| Actual RMS power varies based on box design and on music played |
CAUTION: Earthquake Subwofoers are capable of generating high sound pressure
• Speaker diameter = 8" | CAUTION: |
• Mounting depth = 2 1/8" | THE |
• Cut out mounting hole = 7 7/8" IS FOR FACTORY | |
• Weight = 8 Lbs | UPGRADED VEHICLES |
• Voice Coil diameter = 1.5" | ONLY |
• Aluminum bobbin |
• Power rating RMS = 150W |
• Power rating MAX = 300W |
• Revc = 8=3.76 Ohms / 8Xi=1.76 Ohms |
(52mm) (2 1/8")
(206mm / 8- 1/8")
(cut out hole diameter)
levels. You should exercise caution when operating these subwoofer/amplifier systems. Long term exposures to high levels of sound pressure will cause permanent damage to your hearing. Sound pressure levels exceeding
85dB can be dangerous with constant exposure. Set your audio system to a comfortable loudness level. Earthquake Sound Corporation does not assume liability for damages resulting from the direct use of Earthquake amplifiers or other Earthquake products , and urges users to play their music at moderate listening levels.
SOUND LEVEL DBA
DURATION IN HOURS
| Actual RMS power varies based on box design and on music played |
90
92
8
6
•Speaker diameter = 6.5"
•Mounting depth = 1 3/4"
•Cut out mounting hole = 5 3/4"
•Weight = 5 Lbs
•Voice Coil diameter = 1"
•Aluminum bobbin
•Power rating RMS = 100W
•Power rating MAX = 200W
•Revc = 3.6 Ohms
(45mm) |
(1 3/4") |
(142mm / 5 3/4") |
(cut out hole diameter) |
95
97
100
102
105
110
115
4
3
2
1 - 1 1/2
1
1/2
1/4 or less
OCCUPATIONAL SAFETY AND H E A LT H A D M I N I S T R AT I O N (OSHA) REGULATIONS WHICH WERE IN EFFECT AT THE TIME OF THIS PUBLICATION FOR
P E R M I S S I B L E N O I S E EXPOSURE, PER 29CFR1910.95, TABLE
4 | All Specifications Are Subject To Change Without Notice | www.earthquakesound.com | 5 |