Speaker Installation
Note: Speaker cable should be run to each speaker location prior to speaker installation. In new construction applications, run the speaker wire to the speaker locations prior to drywalling.
To Install
Remove speaker grill first. Locate the mounting brackets on the rear of the speaker.
Pushing Down on the Legs of the Mounting Bracket Releases the Speaker Grill From the Frame
Mounting Bracket
Locked In
Mounting Brackets on Rear of Speaker (Locked In)
Twist the mounting brackets out of their locked position so they can slide down the open channel.
Mounting Bracket
Unlocked Out
Mounting Brackets on Rear of Speaker (Unlocked Out)
Push the brackets down the slide channel towards the front of the speaker, holding onto the speaker frame for support.
Push Down on the Mounting Brackets to
Once the mounting brackets are pushed down, the grill will release from the frame.
Negative
Positive
Speaker Rear View Consisting of a Positive and Negative Wire Set
Next, attach the speaker wire from mounting location to the back of the speaker.
Caution: Make sure to observe polarity (positive + to positive + and negative – to negative
Finally, to mount the speaker, turn all the mounting brackets in toward the speaker. This will allow the speaker to easily fit into the hole you have just cut. Insert the speaker into the hole.
Turn All Mounting Brackets into the “in” Position
Mounting Brackets in the “in” Position
2 | EATON CORPORATION |
