EAW SMS4 instruction manual Installation, Connections

4. INSTALLATION

The special hexagonal shape of the cabinet makes it possible to position the speaker in various way, as shown in the figure. The EAW Commercial plate on the front protective grille can be rotated to adapt it to the position of the speaker. The speaker body has four M6 threaded inserts, one each on the top and bottom and two on the back, used for attaching accessories for installing the speaker in different ways.

The SMS4 (SMS4W) loudspeakers are supplied with a black (white) ball joint support for wall mounting.

WARNING: Consult a professional rigger or structural

engineer prior to suspending loudspeakers from a

structure not intended for that use. Always know the working load limit of the structure supporting the loudspeaker array. Always make sure that the rigging hardware minimum rating is at least five times the actual load.

5. REAR PANEL FEATURES AND CONTROLS

1.This rotary control selects the power tap for the internal constant voltage transformer. Choices are 1W, 5W, 10W, 20W, 30W, and BYPASS (used for 4 ohm operation).

2.This rotary control selects the constant voltage distributed system in which the speaker is used. Choices are BYPASS (used for 4 ohm operation),

0 (Off), 25V, 50V, 70V and 100V.

Note: Use a slot-head screwdriver to adjust the rotary controls.

SMS4		���
���������������������������������������			Ω
��	���	���	���
����	���	�	���
��		������	����

�Ω

6. CONNECTIONS

The spring-loaded speaker terminals are designed to accept bare wire, up to a maximum of 18 gauge. Strip 1/4’’ (6 mm) of insulation off the end of the speaker wire, press in the tab, and insert the bare wire into the hole. When you release the tab, the wire is locked in place. Make sure there are no stray strands of wire outside the terminal connection.

WARNING: To prevent the risk of electrical shock, always fit the protective cover of the terminals after completing connections.

+ -

4 – SMS4