POWER PRUNERTM ATTACHMENT

7

OPERATOR'S MANUAL

Cut only wood. Avoid striking concrete, metal, wire, or other obstructions which could cause kickback or damage to the saw chain.

If the saw chain does strike a foreign object, immediately stop the engine, inspect and repair the Power PrunerTM if necessary.

EQUIPMENT

Before operation a complete check of the unit must be performed;

• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.

DESCRIPTION

Locate this safety decal on your attachment. Make sure the decal is legible and that you understand and follow the instructions on it. If it cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING instructions for specific information.

 

5

 

 

6

4

3

1

 

 

 

2

 

 

 

7

 

9

 

 

 

P/N 89016022660

 

8

 

1.GRIP, FRONT - Cushioned grip for left hand.

2.SHAFT DECAL - Contain important safety information that must be followed.

3.LOWERDRIVESHAFTASSEMBLY-Contains a specially designed liner and the flexible drive shaft.

4.CUTTINGATTACHMENT-Sealed,gearratiois1.5:1reduction.

5.AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.

6.SAWCHAIN- 91 VX 9.53mm (3/8 inch) low profile Oregon® saw chain. Runs approximately 609.6 m/min.

(2000 ft/min) at full throttle.

7.GUIDEBAR-254mm(10inch)Bar

8.CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, accelerate and lower saw chain into branch.

9.GUIDE BAR COVER - Used to cover guide bar and saw chain during transport and storage. Remove guide bar cover before using unit.