3.Use one piece of new nylon line (C) 6 m (20 ft.) long and thread through the molded loop (D) on the spool. Pull line tight and adjust so one end is 15 cm (6 in.) longer than the other.
4.Hold the spool, opening toward you. Place index finger between the two strands and wind line, tightly and evenly, in direction of arrow(E)marked"CC".
5.Stop when approximately
6.Feed ends of line through housing eyelets (G) and place spool (B) over drive (H). Align pegs (I) on drive with notches in spool, and push spool into drum.
7.Pull on both lines until they come free from notches (F) in spool.
8.Hold drum (A) firmly and turn spool (B) CCW (counterclockwise) until it stops. DO NOT push in on spool when turning.
CD
E
C C
B
FF
GI
B
H
G
B
A
9. Pull both lines out and trim to