Echo 99944200615 manual Lubrication, Nylon line replacement

PAS Rapid LoaderTM Curved Shaft Trimmer Attachment 11 Operator's Manual

lubrication

Level 1.

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium Base Grease.

1.Remove plastic shield.

2.Loosen bearing housing locating screw (A), at the top of the hous- ing, loosen mounting screw (B) and remove gear case from drive housing.

3.Pull the flexible drive shaft (C) from the drive housing, wipe clean and recoat with a thin coating [1/2 oz. (15 ml)] of grease.

4.Slide the flexible drive shaft back in the drive housing being care- ful not to get dirt on the flexible drive shaft.

5.Install the bearing housing and shield.

B

A

C

nylon line replacement

Level 1.

Parts Required: Pre-cut Nylon Line

1.Shut engine off. Lay unit on the ground with head assembly up.

2.Remove old nylon line through center recess of head.

3.Insert pre-cut 204 mm (8 in.) length of nylon cutting line (recom- mended sizes 2.4 mm [.095 in.] to 3.9 mm [.155 in.]) through outside openings of trimmer head. Minimum of 153mm (6 in.) of line should extend from each opening. 3.9mm [.155 in.] line not recommended for trimmers under 26cc.

NOTE

Insert cutting line ends to center of head recess to insure easy removal of used lines.

Notice:

Nylon line can damage plastic shield. When installing line seg- ments, make sure line does not curve upward toward shield.

MODELS	REQUIRED LINE SIZES
SRM-2100SB
SRM-210SB/211SB
PAS-210/211	.080 - .095 in.
PAS-225
PAS-230/231
SRM-2400SB	.095 - .130 in.
SRM-260SB/261SB	.095 - .155 in.
PAS-2601
PAS-260/261
PAS-265