18 
NOTE
Blade depth may have to be adjusted due to differences in height between the hard surface and the top of the grass.
4.Loosen blade adjustment knob and adjust the blade’s depth of cut to produce a fine cut between sidewalk and grass using a minimum blade depth, usually with about 13 mm (1/2 in.) of the blade into the ground. Tighten adjustment knob.
5.Before edging, plan your direction of travel so that the unit will always be on your right side and so that you walk on a hard surface whenever possible.
6.Hold edger as shown.
7.When starting to edge, run the engine at full throttle, and lower the blade gently into the ground, being careful not to hit the concrete with the blade.
IMPORTANT
Use the blade location slot in the top of the debris shield as a guide to align the blade with the cut during edging.
8.Do not force the blade. Move only as quickly as the blade will al- low.
WHEEL | ADJUSTMENT |
KNOB | |
| INCREASE |
| DEPTH |
| DECREASE |
| DEPTH |
1/2 in. |
|
