
PREPARATION FOR USE
Bolt (A)
Dimple (D)
Kick Guard®
WARNING
Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result.
KICK GUARD® TO BAR
INSTRUCTIONS
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick Guard® P/N 2893201 and Symmetrical
1. Install bolt (A) in rear hole (B) of Kick Guard® |
and through front hole (C) in guide bar. |
Recess (E)
Nut (F)
Rear hole (B)
Front hole (C)
Guide bar
2. | IMPORTANT: Dimple (D) in Kick Guard® must |
| engage recess (E) in guide bar. |
3. | Tighten nut (F) and bolt (A) using 11 mm (7/16 |
| in.) wrenches until snug. Make certain Kick |
| Guard® is flush against guide bar. |
4. | Tighten nut (F) 1/8 additional turn. |
5. | Check to make certain Kick Guard® is tight on |
| guide bar. |
Brake lever
(Front hand guard)
A nut
Clutch cover
GUIDE BAR AND SAW CHAIN INSTALLATION/REMOVAL
NOTICE
•Move the chain brake lever (Front hand guard) fully rearward to remove or install the clutch cover to chain saw.
1.Remove spark plug lead. (See page 25)
2.Remove the clutch cover nut and remove clutch cover.
3.Remove bar and saw chain if necessary. See “Maintenance and Care” section for guide bar/ saw chain maintenance procedures.
10 |