PREPARATION FOR USE

Bolt (A)

Dimple (D)

Kick Guard®

Rear hole (B)

Recess (E)

Front hole (C)

Nut (F)

Guide bar

WARNING

Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result.

KICK GUARD® TO BAR

INSTRUCTIONS

Tools Needed: Two 11 mm (7/16 in.) Wrenches.

For saws with Kick Guard® P/N 2893201 and Symmetrical Low-Kick type (Double Guard) guide bars.

1.Install bolt (A) in rear hole (B) of Kick Guard® and through front hole (C) in guide bar.

2.IMPORTANT: Dimple (D) in Kick Guard® must engage recess (E) in guide bar.

3.Tighten nut (F) and bolt (A) using 11 mm (7/16 in.) wrenches until snug. Make certain Kick Guard® is flush against guide bar.

4.Tighten nut (F) 1/8 additional turn.

5.Check to make certain Kick Guard® is tight on guide bar.

Unlock chain brake

Brake lever (Front hand guard)

Two nuts

Clutch cover

GUIDE BAR AND SAW CHAIN INSTALLATION/REMOVAL

1.Remove spark plug lead. (See page 25)

2.Remove two clutch cover nuts and remove clutch cover.

3.Remove bar and saw chain if necessary. See “Maintenance and Care” section for guide bar/ saw chain maintenance procedures.

CS-352

10

Page 12
Image 12
Echo CS-352 Preparation for USE, Kick Guard to BAR Instructions, Guide BAR and SAW Chain INSTALLATION/REMOVAL