Chain brake
Ignition switch
Throttle trigger lockout
START/RUN
PUSH |
|
Throttle latch | Throttle trigger |
|
WHEN THE ENGINE IS HARD TO START
CAUTION
Make sure bar and chain are free from any obstruction when starting the saw.
•Move chain brake lever fully forward to engage chain brake before starting.
•Press throttle trigger lockout down while grasping throttle trigger and push in throttle latch.
•Move ignition switch to “RUN” position.
•Securely hold the chain saw as shown and pull starter handle.
•When engine starts, immediately squeeze throttle trigger, to release throttle latch, and pull front hand guard towards the operator immediately. (Chain brake RELEASED position)
Starter handle 
Release chain brake 
CAUTION
1.When using throttle latch for starting, keep the brake in brake position.
2.After starting the engine, squeeze throttle trigger slightly to release throttle latch and pull front hand guard towards the operator immediately.
(Chain brake RELEASED position)
3.Do not increase engine speed while chain brake is engaged.
4.Use the chain brake only in starting or in emergencies.
Choke control knob
OPEN CHOKE
Release chain brake 
CAUTION
The chain will attempt to rotate when engine is started with throttle latch engaged.
After engine starts, release throttle trigger to idle engine, otherwise brake damage may occur. Never use throttle latch for cutting. Use it only when starting the engine.
WHEN THE ENGINE IS WARM
•Move chain brake lever fully forward to engage chain brake before starting.
•Confirm there is fuel and chain oil in the tanks.
•Move ignition switch to “RUN” position.
•Securely hold the chain saw as shown and pull starter handle.
•Choke may be used if necessary, but be sure to push it back on first firing sound.
•After starting the engine, pull front hand guard towards the operator immediately. (Chain brake RELEASED position)
12 |