| DESCRIPTION |
|
|
3. Clutch - Turns drive sprocket when engine rpm is fast enough to provide the power needed for cutting.
Preparation For Use
Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result.
Note: The machine may be delivered with guide bar, tip guard, and saw chain separated. Install guide bar, tip guard, and saw chain as follows.
Tip Guard to Bar Instructions
Tools Needed: Two 11 mm (7/16 in.) Wrenches. For saws with tip guard P/N 2893201 and Symmetrical or Asymmetrical
1.Install bolt (A) in rear hole (B) of tip guard and through front hole (C) in guide bar.
2.IMPORTANT: Dimple (D) in tip guard must engage recess (E) in guide bar.
3.Securely tighten nut (F) and bolt (A).
For more information scan this QR code.
A
D
B
E
C
F
Guide Bar and Saw Chain Installation/Removal
Note: Align the brake connector (B) of the sprocket guard to the groove on the side of the brake lever (Front hand guard).
1.Remove air cleaner cover and disconnect spark plug lead.
2.Move the chain brake lever (A) (Front hand guard) fully rearward to remove or install the sprocket guard (C).
3.Remove sprocket guard nuts (D) and remove sprocket guard
(C).
4.Remove guide bar and saw chain if necessary.
Note: See “Maintenance and Care” section for guide bar/saw chain maintenance procedures.
For more information scan this QR code.
A
B
C
D
X7503251407 | 15 |
© 12/2013 ECHO Inc.
