Starter handle
Choke control knob 
Open choke
Lock Chain brake
Choke control knob 
Open choke
•Securely hold the chain saw as shown and pull starter handle several times until first firing sound.
•Push choke control knob all the way in.
WARNING•After choke control knob is pulled and then knob is returned to original position, throttle remains a little open (latch condition).
•If engine is started in this latch condition, chain starts to turn. Do not start engine before chain brake is activated.
•Pull starter handle to start the engine.
NOTE
If engine does not start after 5 pulls, repeat instruc- tions.
•When engine starts, immediately squeeze throttle trig- ger to release the latch, otherwise damage to clutch may result.
WHEN THE ENGINE IS WARM•Move chain brake lever fully forward to lock chain brake before starting.
•Confirm there is fuel and chain oil in the tanks.
•Move ignition switch to “RUN” position.
•Securely hold the chain saw as shown and pull starter handle.
•Choke may be used if necessary, but be sure to push it back on first firing sound.
NOTE
If engine does not start after 5 pulls, use cold start procedure.
16