PREPARATION FOR USE
Bolt (A)
Front hole (B)
Dimple (D)
Kick Guard®
Front hole (C)
Recess (E)
Nut (F)
Guide bar
Unlock chain brake
Brake lever (Front hand guard)
Spiked bumpers
Two nuts
Clutch cover
Clutch | Guide bar studs |
Clutch cover |
|
Guide bar adjuster hole | Nuts |
WARNING
Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result.
KICK GUARD® TO BAR
INSTRUCTIONS
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick Guard® P/N 2893201 and Symmetrical
1.Install bolt (A) in front hole (B) of Kick Guard® and through front hole (C) in guide bar.
2.IMPORTANT: Dimple (D) in Kick Guard® must engage recess (E) in guide bar.
3.Tighten nut (F) and bolt (A) using 11 mm (7/16
in.) wrenches until snug. Make certain Kick Guard® is flush against guide bar.
4.Tighten nut (F) 1/8 additional turn.
5.Check to make certain Kick Guard® is tight on guide bar.
GUIDE BAR AND SAW CHAIN INSTALLATION/REMOVAL
1.Remove spark plug lead. (See page 25)
2.Remove two clutch cover nuts and remove clutch cover.
3.Remove bar and saw chain if necessary. See “Maintenance and Care” section for guide bar/ saw chain maintenance procedures.
4.Unlock the chain brake, and mount guide bar on studs and slide toward clutch to make saw chain installation easier. Install chain with cutters on top of guide bar facing forward.
5.Install the clutch cover over the guide bar studs. Ensure chain tension adjuster pin fits into the guide bar adjuster hole. Tighten clutch cover nuts finger tight.
10 |